E3Switch DS3 Spécifications Page 17
- Page / 30
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 6: Interoperability
If LAN equipment appears to disable a port connected to the converter, be aware that “sophisticated”
routers and switches will often disable a LAN port if data being sent appears similar to data or MAC
addresses being received, as is the case in telecom loopback.
Autonegotiation problems
There are rare cases with older LAN equipment in which it may be necessary to disable autonegotiation. If
crc-errors or short packet errors are seen in the management statistics of the LAN port, the attached LAN
equipment has probably configured itself to half-duplex mode and colliding packets are being lost. In such
a case, autonegotiation should be disabled on both the converter and the attached LAN equipment with both
forced to 100BaseTX full-duplex. Autonegotiation interoperability and standards were not well understood
by the industry at the inception of 100BaseTX, resulting in some older LAN equipment not understanding
the converter's autonegotiation advertisement of strictly full-duplex capability.
It is highly desireable to leave autonegotiation enabled so that changing attached LAN equipment does not
result in the new equipment defaulting to half-duplex if set to autonegotiate.
SFP LAN Port 1
This port is designed to be compatible with inexpensive, high-quality, copper or fiber-optic, SFP
transceivers from Finisar, which allows LAN connections of 10km or more. Most other industry-standard
SFP transceivers will work as well; however, fiber-optic features such as temperature and optical
transmit/receive power and alarms will only be available if using Finisar transceivers. Non-Finisar copper,
RJ45 SFP transceivers may only operate in 1000Base-T mode, while recommended transceivers from
Finisar, and possibly Avago or 3Com will operate in 100Base-TX mode as well.
Pause Frames
Unless disabled in the settings or through autonegotiation, the converter sends pause command frames to
attached LAN equipment when the converter's incoming LAN buffers become nearly full. The converter
ignores pause command frames sent to it.
VoIP / Video or High-CoS Priority Frames
Receive queue space is reserved in the converter to allow frames with high 802.1p class-of-service (CoS)
priority settings to bypass existing frames waiting to be transmitted to the DS3/E3. This allows voice, video
and other high-priority traffic to experience low-latency transmission. Firmware shipped since July 2008
allows the “high” CoS level to be configured. Prior firmware has the high-CoS level set at >=6.
Telecom
The converter can transmit over a variety of E3 or T3/DS3 links (with appropriate media converters) such
as fiber optic, microwave radio, laser, copper, satellite, or a combination; however, the attachment interface
is always via 75-ohm copper coaxial rather than optical. The point-to-point telecom link must be
unchannelized, i.e., not subdivided into T1 or E1 channels. The telecom link may be either framed or
unframed and supports both M13, M23, clear-channel, C-Bit, and G.751 framing. C-Bit framing is
suggested for DS3 links.
Be aware that during loopback testing, “sophisticated” routers and switches will often disable a LAN port if
data being sent appears similar to data or MAC addresses being received. This can cause confusion.
Fiber/Copper Media Converters
Transition Networks DS3/E3 Coax to Fiber Media Converter, SCSCF3014-100 has been reported to lack
the ability to properly maintain separate DS3/E3 transmit clock speeds in each direction and are not
recommended. This problem typically manifests itself as frame slips or loss of telecom signal lock in one
direction at a rapid, consistent periodic rate, which is proportional to the difference in clock speeds of each
telecom direction. If such media converters are already in use, setting the DS3/E3 transmit clock source of
one of the E3Switch units to “loop” may alleviate problems.
17
- High-Speed Ethernet to 1
- Single/Dual DS3/E3 1
- Network Extender V5.4 1
- Operating Information 1
- Legal Preface: 2
- TABLE OF CONTENTS 4
- Chapter 2: Quick Set-up 7
- Chapter 3: Front Panel 8
- Front Panel Indicators 8
- Unit's IP/MAC Address 8
- ● .51.bbb => .51.bbb 9
- ● .15.bbb => .49.bbb 9
- ● IP3.bbb => 51.bbb 9
- Management Passwords 10
- Security 10
- HTTP Management 11
- Upgrading Firmware 11
- Feature Activation/Upgrade 12
- Packet Flow 13
- Port to Port Packet Flow 13
- LAN Port Settings 14
- Chapter 6: Interoperability 16
- Fiber/Copper Media Converters 17
- LAN Cabling 19
- LAN Packet Priority 19
- LAN Packet Order 19
- Loopback of DS3 21
- Performance 23
- Interoperability 23
- Laboratory Testing 23
- Step-by-Step Diagnosis 24
- The FreeBSD Copyright 25
- The Net-SNMP Copyright 26
- The Apache License 27
- The SHA2 Copyright 28
- The BZIP2 License 28
- The atHTTPD License 28
- For More Information: 29
- ©2011, E3Switch LLC 30
Produits connexes et manuels pour Passerelles/contrôleurs E3Switch DS3
Fujifilm 30i Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kameras Fujifilm 30i.
Wir stellen 1 PDF-Handbücher Fujifilm 30i zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Fujifilm 30i Bedienungsanleitung (59 Seiten)
Marke: Fujifilm | Kategorie: Cameras | Größe: 2.12 MB |
Inhaltsverzeichnis
1AUTO MODE
13
01 02 01 02
19
‘ (➡P.101)
33
USING MUSIC
36
7 Settings
40
Macintosh
45
Safety Notes
56
Weitere Produkte und Handbücher für Kameras Fujifilm
| Modelle | Dokumententyp |
|---|---|
| A210 |
Bedienungsanleitung
FujiFilm A210 User Manual,
43 Seiten
|
| FinePix A120 |
Bedienungsanleitung
FujiFilm FinePix A120 User Manual,
43 Seiten
|
| FINEPIX JZ200 series |
Bedienungsanleitung
FujiFilm FINEPIX JZ200 series User Manual [en] ,
114 Seiten
|
| FinePix 30i |
Bedienungsanleitung
FujiFilm FinePix 30i User Manual,
2 Seiten
|
| A310 |
Bedienungsanleitung
FujiFilm A310 User Manual,
43 Seiten
|
| F450 |
Bedienungsanleitung
FujiFilm F450 User Manual,
51 Seiten
|
| DIGITAL CAMERA X-E1 |
Bedienungsanleitung
FujiFilm DIGITAL CAMERA X-E1 User Manual,
136 Seiten
|
| A203 |
Bedienungsanleitung
FujiFilm A203 User Manual,
67 Seiten
|
| FinePix A800 |
Bedienungsanleitung
FujiFilm FinePix A800 User Manual,
164 Seiten
|
| FinePix A205S |
Bedienungsanleitung
FujiFilm FinePix A205S User Manual,
43 Seiten
|
| E510 |
Bedienungsanleitung
FujiFilm E510 User Manual,
59 Seiten
|
| A470 |
Bedienungsanleitung
FujiFilm A470 User Manual,
61 Seiten
|
| 1400 |
Bedienungsanleitung
FujiFilm 1400 User Manual,
45 Seiten
|
| 3100ixZ |
Bedienungsanleitung
FujiFilm 3100ixZ User Manual,
47 Seiten
|
| FinePix 420 |
Bedienungsanleitung
FujiFilm FinePix 420 User Manual,
47 Seiten
|
| Finepix 4700 |
Bedienungsanleitung
FujiFilm Finepix 4700 User Manual,
4 Seiten
|
| A330 |
Bedienungsanleitung
FujiFilm A330 User Manual,
47 Seiten
|
| DIGITAL CAMERA FINEPIX F800EXR |
Bedienungsanleitung
FujiFilm DIGITAL CAMERA FINEPIX F800EXR User Manual,
171 Seiten
|
| F45fd |
Bedienungsanleitung
FujiFilm F45fd User Manual,
180 Seiten
|
| 2400 |
Bedienungsanleitung
FujiFilm 2400 User Manual,
43 Seiten
|
© 2020, manymanuals.fr. Tous droits réservés | 0.055 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels